Mazda 6 manuals

Mazda 6 Service Manual: Front fender panel

Mazda 6 Service Manual / Body / Front fender panel

FRONT FENDER PANEL REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the front side turn light.

3. Remove the fender molding. (See COWL GRILLE REMOVAL/INSTALLATION.)

4. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)

5. Remove the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)

6. Remove in the order indicated in the table.



7. Install in the reverse order of removal.

Bonnet adjustment
Gap Adjustment 1. Remove the front fender. 2. Loosen the bonnet hinge installation bolts and reposition the bonnet. 3. Tighten the bolts. 4. Verify that the gap between the bonnet and the body i ...

Door
...

Other materials:

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm system inspection
System Inspection Preparation 1. Verify that the battery is fully charged. With the ignition switch on, verify that the ABS and BRAKE system warning lights goes out after 2.4 seconds. 2. If the lights stays on after 2.4 seconds, the ABS (ABS/TCS) HU/CM detects a failure. Follow the troubles ...

Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing the ATF. 1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.) 2. Disconnect the TFT sensor connector. 3. Remove the TFT sensor. 4. Install a TFT senso ...

© 2016-2026 Copyright www.mazda6info.net