Mazda 6 Service Manual: Clutch master cylinder

Clutch pedal removal/installation

1. Remove the battery and battery tray. (European (L.H.D.) and GCC specs.) 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. After installation, adjust t ...

Clutch master cylinder removal/installation

1. Remove the battery and battry tray. (European (L.H.D.), GCC. specs.) 2. Remove in the order indicated in the table. 3. Plug the clutch pipe after removing it to avoid leakage. 4. Install in the ...

Other materials:

Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket. 2. Disconnect the DSC HU/CM connector. 3. Connect the SST (49 G066 004) to the DSC HU/CM connector and harness side connector. 4. Inspect voltage referring the table below. Terminal Voltage Table (reference value) (Ignition switch is at ON, and conne ...

Mazda 6 Service Manual: Air mix actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air mix actuator. 2. Verify that the air mix actuator operates as shown below. If not as specified, replace the air mix actuator. e 3. Verify that the resistance between the terminals of the ...