Mazda 6 manuals

Mazda 6 Service Manual: Clutch

Starter inspection
On-vehicle Inspection 1. Verify that the battery is fully charged. 2. Crank the engine and verify that the starter rotates smoothly without any noise. If not, inspect the following. - Re ...

Location index
...

Other materials:

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Service Manual: Audio control switch removal/installation
Note The audio control switch and the cruise control switch use a common connector. 1. Disconnect the negative battery cable. 2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.) 3. Remove the steering wheel. 4. Remove in the order indicated ...

© 2016-2026 Copyright www.mazda6info.net