Mazda 6 Service Manual: Clutch release cylinder

Clutch master cylinder disassembly/assembly

1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Snap Ring Disassembly/Assembly Note Hold the piston down using a cloth-wrapped pin punch. ...

Clutch release cylinder removal/installation

1. Remove the under cover. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: Recommended Tire Inflation Pressure
On the tire label you will find the recommended tire inflation pressure in both kPa and psi for the tires installed as original equipment on the vehicle. It is very important that the inflation pressure of the tires on your vehicle is maintained at the recommended pressure. You should check t ...

Mazda 6 Service Manual: A/c compressor removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the right side splash shield and mudguard (L.H.D. only). 4. Loosen the drive belt and remove it. Caution If moisture or foreign material enters the refrigeration ...