Mazda 6 manuals

Mazda 6 Owners Manual: Dashboard Illumination

(Without auto-light control)

When the position lights are turned on with the ignition switched ON, the brightness of the dashboard illumination is dimmed.

(With auto-light control)

When the position lights are turned on with the ignition switched ON, the brightness of the dashboard illumination is dimmed. However, when the light sensor detects that the surrounding area is bright such as when the position lights are turned on in the daytime, the dashboard illumination does not dim.

NOTE

The brightness of the instrument cluster and dashboard illuminations can be adjusted by rotating the knob.


Function for cancelling illumination dimmer

The illumination dimmer can be canceled by rotating the dashboard illumination knob to the right until a beep sound is heard while the instrument cluster is dimmed with the ignition switched ON.

If the instrument cluster's visibility is reduced due to glare from surrounding brightness, cancel the illumination dimmer.

NOTE

Fuel Gauge (Without Multiinformation Display)
The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full. If the low fuel warning light illumina ...

Outside Temperature Display (Without Multi-information Display)
When the ignition is switched ON, the outside temperature is displayed. NOTE Under the following conditions, the outside temperature display may differ from the actual outside temperature depend ...

Other materials:

Mazda 6 Owners Manual: No.1 abs warning light, brake system warning light, tcs off light do not illuminate with ignition switch on
Vehicle with ABS/TCS When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure conn ...

Mazda 6 Owners Manual: Filament repair
1. Use isopropyl alcohol to clean around the damaged section of the filament. 2. Attach tape above and below the damaged section of the filament. 3. Using a small brush or marking pen, repair the filament with silver paint or equivalent. 4. After 2-3 minutes, carefully remove the tape without ...

© 2016-2023 Copyright www.mazda6info.net