
Diagnostic procedure

Dtc 03:er02
Dtc 00:er01Mazda 6 Service Manual: Clock spring inspection
1. Remove the clock spring.
2. Inspect for continuity between the clock spring terminals using an
ohmmeter.
If not as specified, replace the clock spring.
Note
When the vehicle-side connector of clock spring is disconnected,
the terminals 1A,1B, 1C and 1D are shorted to prevent ...
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable.
2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness
connector with the ignition switch off.
3. Attach the tester leads to the SST and inspect voltage referring
the table below.
Terminal Voltage Table (Reference)
(Engine is idling, and co ...