Diagnostic procedure
Mazda 6 Service Manual: Front stabilizer removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET.)
5. Inspect the front wheel alignment. (See FRONT WHEEL A ...
Mazda 6 Service Manual: Glass panel adjustment
1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
3. If not as specified, loosen the glass panel installation screws and
reposition the glass panel.
Clearance
a: -0.8-1.2 mm {-0.032-0.047 in}
b: 0 mm {0 in}
4. Tighten the installation scre ...