Mazda 6 Service Manual: On-board diagnostic [cruise control system]

Diagnostic assist function

Structural View Switch location LCD Inspection 1. With audio on, first press the POWER button, then simultaneously press the SEEK button (upper) for approximately 1 second. 2. Inspect the LC ...

Foreword

Outline There are two on-board diagnostic functions: Operation mode, which inspects for and indicates correct operation of the input signals to the control module, and condition detection mo ...

Other materials:

Mazda 6 Service Manual: Foreword
Caution When the engine does not start or stalls and the following DTCs are not indicated, go to engine symptom troubleshooting. Note When the immobilizer system is defective, the engine cannot be started. If engine condition is normal but light stays on, inspect for short circ ...

Mazda 6 Service Manual: Clutch switch inspection
Note Perform the following inspection only when directed. Continuity Inspection 1. Verify that the clutch switch is installed properly. 2. Disconnect the negative battery cable. 3. Remove the clutch switch. 4. Inspect for continuity between the clutch switch terminals using an ohmmeter. ...