Mazda 6 Service Manual: Dtc 15

Dtc 13

On-board diagnostic [air bag system]

Other materials:

Mazda 6 Service Manual: Thermostat
THERMOSTAT REMOVAL/INSTALLATION 1. Remove the plug hole plate. 2. Disconnect the negative battery cable. 3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) 4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.) 5. Remove the washer tank. 6. Remove the P/S oil pump. Note ...

Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable. 2. Remove the plug hoie plate. Lift off and remove the plug hole plate from the installation areas (rubber and clips) as shown in the figure. 3. Disconnect the high-tension lead. 4. Remove the spark plugs using the plug-wrench. 5. Install th ...