Diagnostic procedure
Mazda 6 Service Manual: Condenser removal/installation
4SD
1. Disconnect the negative battery cable.
2. Remove the rear package trim.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5HB
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim.
3. Remove in the order indicated in t ...
Mazda 6 Service Manual: Foreword
Caution
When the engine does not start or stalls and the following DTCs
are not indicated, go to engine symptom troubleshooting.
Note
When the immobilizer system is defective, the engine cannot be
started.
If engine condition is normal but light stays on, inspect for
short circ ...