Mazda 6 Service Manual: Dtc p0103

Dtc p0102

Dtc p0107

Other materials:

Mazda 6 Service Manual: Solenoid valve removal/installation
1. Disconnect the negative battery cable. 2. Remove the under cover. 3. Remove the control valve body. (See CONTROL VALVE BODY REMOVAL.) 4. Remove the solenoid valve(s). 5. Apply ATF to a new O-ring and install it on the solenoid valve. 6. Install the solenoid valve in the control valve body. ...

Mazda 6 Service Manual: Rear beltline molding removal
Note When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one. 1. Pull the A section upward and remove the clip. 2. Rotate the B section of the front beltline molding in direction (2), along the direction (1) shown in the figu ...