Mazda 6 Service Manual: Fuel-filler lid and opener removal/installation
1. To remove the fuel-filler lid opener, remove the left side trunk side trim (4SD) or trunk side lower trim (5HB).
2. To remove the fuel-filler lid opener cable, perform the following and turn over the floor covering.
(1) Remove the driver-side front seat.
(2) Remove the driver-side front scuff plate.
(3) Remove the driver-side rear scuff plate.
(4) Remove the driver-side B-pillar lower trim.
(5) Remove the driver-side tire house trim.
(6) Remove the rear seat cushion. (R.H.D., 4SD)
(7) Remove the rear seat installation bolts (front side), then lift the rear seat cushion. (R.H.D., 5HB)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the fuel-filler lid. (See FUEL-FILLER LID ADJUSTMENT.)
Fuel-filler lid adjustment
1. If not as specified, loosen the fuel-filler lid installation bolts, and
reposition the fuel-filler lid.
2. Measure the gap and height between the fuel-filler lid and the body.
Clearance
a: ...
Other materials:
Mazda 6 Service Manual: Air mix actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal
F or D of the air mix actuator.
2. Verify that the air mix actuator operates as shown below.
If not as specified, replace the air mix actuator.
e
3. Verify that the resistance between the terminals of the ...
Mazda 6 Service Manual: Front door speaker removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door trim.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Front Door Speaker Installation Note
Attach the speaker with the wiring harness placed in the groove of the door
unit panel.
...