Mazda 6 Owners Manual: Multi-Information Display and INFO Switch (Some models)
The multi-information display indicates the following information.
- Odometer
- Trip meter
- Engine coolant temperature gauge
- Fuel gauge
- Outside temperature
- Distance-to-empty
- Average fuel economy
- Current fuel economy
- Maintenance Monitor
- Blind Spot Monitoring (BSM) Display
- Distance Recognition Support System (DRSS) Display
- Mazda Radar Cruise Control (MRCC) Display
- Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) Display
- Cruise Control Display
- Compass Display
- Warning message
The screen content changes each time the INFO switch is pressed.
*1:Displayed only when a warning occurs.
*2:Displayed only while vehicle is being driven.
- Odometer, Trip Meter and Trip Meter Selector
- Engine Coolant Temperature Gauge
- Fuel Gauge
- Outside Temperature Display
- Distance-to-empty
- Average Fuel Economy
- Current Fuel Economy
- Maintenance Monitor
- Blind Spot Monitoring (BSM) Display
- Distance Recognition Support System (DRSS) Display (Some models)
- Mazda Radar Cruise Control (MRCC) Display (Some models)
- Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) Display (Some models)
- Cruise Control Set Vehicle Speed Display (Some models)
- Compass Display
- Warning (Display Indication)
Trip Computer and INFO Switch (Without Multi-information Display)
The following information can be selected by pressing the INFO switch with the
ignition switched ON.
Distance-to-empty mode
Average fuel economy mode
Current fuel economy mode
Compass mode ...
Odometer, Trip Meter and Trip Meter Selector
The odometer is constantly displayed on the screen when the ignition is switched
ON, and the TRIP A or TRIP B screen can be displayed by operating the INFO switch.
Odometer
The odometer records ...
Other materials:
Mazda 6 Owners Manual: Engine coolant temperature (ect) sensor removal/installation
Warning
When the engine is hot, it can badly burn. Turn off the engine and
wait until it is cool before removing the ECT sensor.
1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
2. Disconnect the ECT sensor connector.
3. Remove the ECT sensor.
4. Install in the reve ...
Mazda 6 Owners Manual: Side protector installation
1. Remove the adhesive remaining on the side protector (if it will be reused)
and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector
(if it will be reused) and the body.
3. Attach double-sided adhesive tape to the side protector as shown (if it ...