Mazda 6 Service Manual: Engine oil inspection
1. Position the vehicle on level ground.
2. Warm up the engine to normal operating temperature.
3. Stop the engine and wait for 5 min.
4. Remove the dipstick.
5. Verify that the oil level is between the F and L marks on the dipstick and check the engine oil condition.
- If the oil level is below the L mark, add the oil.
Engine oil
...
Engine oil replacement
Warning
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil has cooled.
A vehicle that is lifted but not securely supported on safety
...
Other materials:
Mazda 6 Service Manual: How to Use the Bluetooth® Audio System
Switching to Bluetooth® audio mode
To listen to music or voice audio recorded to a Bluetooth® audio device, switch
to the Bluetooth® audio mode to operate the audio device using the audio system
control panel.
Any Bluetooth® audio device must be paired to the vehicle's Bluetooth® unit bef ...
Mazda 6 Service Manual: Headlight cleaner switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Cleaner Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs
of the headlight cleaner switch.
2. Pull ...