Mazda 6 Service Manual: Lubrication system

Oil control valve (ocv) inspection

L3 Coil Resistance Inspection 1. Disconnect the negative battery cable. 2. Disconnect the oil control valve connector. 3. Measure the resistance between terminals A and B using an ohmmeter. If ...

Location index

...

Other materials:

Mazda 6 Service Manual: General procedures
PRECAUTION (BRAKES) Wheels and Tires Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}. Brake Lines Disconnection/Connection Cautio ...

Mazda 6 Service Manual: Engine coolant temperature (ect) sensor removal/installation
Warning When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. 1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) 2. Disconnect the ECT sensor connector. 3. Remove the ECT sensor. 4. Install in the reve ...