Mazda 6 Service Manual: Oil filter
OIL FILTER REPLACEMENT
For Europe (LF and L3 engine models)
Caution
- To avoid damage to the oil filter, use only specified oil filter.
1. Remove the oil filter drain plug.
2. Untighten the oil filter cover for 2 turns and drain the engine oil.
Note
- Oil could be easily drained when the air is in the filter.
3. Remove the oil filter.
4. Use a clean rag to wipe off the mounting surface on the oil filter adapter and the oil filter cover.
5. Apply clean oil to new O-ring of a new oil filter and a new oil filter drain plug.
6. Install the oil filter, oil filter drain plug, and oil filter cover.
7. Tighten the oil filter cover and oil filter drain plug.
Tightening torque: Oil filter cover: 30-35 N·m {30.5-3.56 kgf·cm, 22.2-25.8 in·lbf} Oil filter drain plug: 9.0-11 N·m {91.8-112.1 kgf·cm, 79.6-97.3 in·lbf}
8. Start the engine and inspect for oil leakage.
9. Inspect the oil level.
- If necessary, add oil. (See ENGINE OIL INSPECTION.)
Engine oil replacement
Warning
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil has cooled.
A vehicle that is lifted but not securely supported on safety
...
Oil cooler
LF, L3
1. Remove the under cover.
2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
3. Remove the oil filter cover, and drain the engine oil into a container.
(See OIL FILTER REPLACE ...
Other materials:
Mazda 6 Service Manual: Location index
INTAKE-AIR SYSTEM
FUEL SYSTEM
Engine Room Side
Fuel tank side
EMISSION SYSTEM
Engine room side
CONTROL SYSTEM
...
Mazda 6 Service Manual: Liftgate disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim.
3. To remove the liftgate outer handle and liftgate key cylinder, remove the
rear finisher.
4. To remove the stud ball, separate the stud ball and the stay damper.
5. Disassemble in the order indicated in the table.
...