Mazda 6 manuals

Mazda 6 Service Manual: Oil cooler

LF, L3

1. Remove the under cover.

2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)

3. Remove the oil filter cover, and drain the engine oil into a container. (See OIL FILTER REPLACEMENT.)

4. Remove in the order indicated in the table.

 

5. Use a clean rag to wipe off the mounting surface on the oil cooler.

6. Install in the reverse order of removal.

7. Inspect the oil level.

8. Start the engine and inspect for oil leakage.



Oil filter
OIL FILTER REPLACEMENT For Europe (LF and L3 engine models) Caution To avoid damage to the oil filter, use only specified oil filter. 1. Remove the oil filter drain plug. 2. Untighten the ...

Oil pan
OIL PAN REMOVAL/INSTALLATION Warning Hot engine and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled. 1. Disconnect the negative batte ...

Other materials:

Mazda 6 Service Manual: TCS/DSC Indicator Light
This indicator light stays on for a few seconds when the ignition is switched ON. If the TCS or DSC is operating, the indicator light flashes. If the light stays on, the TCS, DSC or the brake assist system may have a malfunction and they may not operate correctly. Take your vehicle to an Auth ...

Mazda 6 Service Manual: Outside Temperature Display (Without Multi-information Display)
When the ignition is switched ON, the outside temperature is displayed. NOTE Under the following conditions, the outside temperature display may differ from the actual outside temperature depending on the surroundings and vehicle conditions: Significantly cold or hot temperatures. Sudden ...

© 2016-2026 Copyright www.mazda6info.net