

Oil pressure inspectionMazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over.
2. Disengage clips A using a fastener remover.
3. Pull the A-pillar trim, then disengage clip B (1).
4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar
trim (2).
5. Pull clip B out, then rotate 45°.
6. Remove clip B from the grommet b ...
Mazda 6 Service Manual: Dtc c1095, c1096
Caution
When attaching the tester lead to the ABS (ABS/TCS) HU/CM harnesses
connector the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM
INSPECTION.)
Diagnostic procedure
...