Mazda 6 manuals

Mazda 6 Service Manual: Relay inspection

Relay Type


Four-terminal

Type A

1. Remove the relay.

2. Inspect for continuity between the relay terminals using an ohmmeter.



Type B

1. Remove the relay.

2. Inspect for continuity between the relay terminals using an ohmmeter.



Type C

1. Remove the relay.

2. Inspect for continuity between the relay terminals using an ohmmeter.



Relay location
...

Exterior lighting system
...

Other materials:

Mazda 6 Service Manual: Joint shaft disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Joint Shaft Disassembly Note Disassemble the joint shaft. Bearing Disassembly Note Remove the bearing using the SSTs. Dust Seal (Right) Assembly Note 1. Apply grease to the new dust se ...

Mazda 6 Service Manual: Running light unit inspection
1. Connect the connector to the running light unit. 2. Connect the negative battery cable. 3. Measure the voltage at the running light unit using voltmeter. When inspecting terminal D, H or P for continuity, disconnect the running light unit connector. 4. If the value are not as specif ...

© 2016-2026 Copyright www.mazda6info.net