Mazda 6 Service Manual: Power system
- Fuse service caution
- Main fuse removal/installation
- Fuse block removal/installation
- Ignition switch removal/installation
- Ignition switch inspection
- Key reminder switch removal/installation
- Key reminder switch inspection
- Cigarette lighter removal/installation
- Cigarette lighter inspection
- Relay location
- Relay inspection
Air bag system
...
Fuse service caution
Caution
Determine and correct the cause of the burnt fuse before replacing
it with the specified type. If the fuse is replaced before doing this, it
may burn again.
...
Other materials:
Mazda 6 Service Manual: Remote handle lever removal/installation
4SD
1. To remove the remote wire, remove the trunk side trim.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
5HB
1. To remove the remote wire, remove the trunk side upper trim and trunk side
trim.
2. Remove in the order indicated in the table.
...
Mazda 6 Service Manual: Variable tumble control solenoid valve inspection
1. Remove the variable tumble control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the variable tumble control solenoid valve.
If as specified, carry out the Circuit Open/Short ...