Mazda 6 manuals

Mazda 6 Service Manual: Evaporator temperature sensor inspection

Mazda 6 Service Manual / Heater and air conditioner systems / Control system / Evaporator temperature sensor inspection

1. Turn the AUTO switch on.

2. Set the temperature control at MAX COLD (Turn the left).

3. Turn the A/C switch.

4. Set the RECIRCULATE mode.

5. Close all doors and windows.

6. Wait for 5 minutes.

7. Remove the glove compartment.


8. Disconnect the evaporator temperature sensor.

9. Measure the temperature at the blower inlet.

10.Measure the resistance between terminals of the evaporator temperature sensor.

Evaporator temperature sensor removal/installation
Remove the evaporator temperature sensor from the A/C unit. (See A/C UNIT DISASSEMBLY/ASSEMBLY.) ...

Water temperature sensor removal/installation
1. Disconnect the negative battery cable. 2. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION.) 3. Remove in the order indicated in the table. 4. Install in the reverse order of remova ...

Other materials:

Mazda 6 Service Manual: Tire Maintenance
Improper or inadequate vehicle maintenance can cause tires to wear abnormally. Here are some important maintenance points: Tire Inflation Pressure Inspect all tire pressure monthly (including the spare) when the tires are cold. Maintain recommended pressures for the best ride, top handling, an ...

Mazda 6 Service Manual: Panel light control switch removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Panel Light Control Switch Removal Note 1. Insert your hand from the lower side of the dashboard and squeeze the tabs of the panel light control switch. 2. ...

© 2016-2026 Copyright www.mazda6info.net