Mazda 6 manuals

Mazda 6 Service Manual: Evaporator temperature sensor removal/installation

Mazda 6 Service Manual / Heater and air conditioner systems / Control system / Evaporator temperature sensor removal/installation

Remove the evaporator temperature sensor from the A/C unit. (See A/C UNIT DISASSEMBLY/ASSEMBLY.)

Cabin temperature sensor inspection
1. Measure the temperature around the cabin temperature sensor. 2. Measure the resistance between terminals of the cabin temperature sensor. If the resistance is not as shown in the graph, replac ...

Evaporator temperature sensor inspection
1. Turn the AUTO switch on. 2. Set the temperature control at MAX COLD (Turn the left). 3. Turn the A/C switch. 4. Set the RECIRCULATE mode. 5. Close all doors and windows. 6. Wait for 5 minutes. ...

Other materials:

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

Mazda 6 Service Manual: Pid/data monitor inspection
  1. Connect the WDS or equivalent to the DLC-2. 2. Measure the PID value. Note Perform part inspection for the output device after PCM inspection. The PID/DATA MONITOR function monitors the calculated value of the input/output signals in the PCM. Therefore, if a monitored value ...

© 2016-2026 Copyright www.mazda6info.net