Mazda 6 Service Manual: Headlight leveling switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Leveling Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs of the headlight leveling switch.
2. Pull the headlight leveling switch forward to remove it.
HEADLIGHT LEVELING SWITCH INSPECTION
1. Remove the headlight leveling switch. (See HEADLIGHT LEVELING SWITCH REMOVAL/INSTALLATION.)
2. Inspect for continuity between the headlight leveling switch terminals using an ohmmeter.
- If not as specified, replace the headlight leveling switch.
Front and rear fog light switch inspection
Light switch LH side
1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION.)
2. Inspect for continuity between the light switch terminals using an
ohmmeter.
If not as specified, r ...
Back-up light switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: General procedures
Wheels and Tires Removal/Installation
The removal and installation procedures for the wheels and tires are not
mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m
{9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
Power Steering Components Removal/Installation
If any power steeri ...
Mazda 6 Service Manual: Smart Brake Support (SBS) (Some models)
The Smart Brake Support (SBS) system alerts the driver of a possible collision
using a display and warning sound if the radar sensor (front) and the Forward Sensing
Camera (FSC) determine that there is the possibility of a collision with a vehicle
ahead while the vehicle is being driven at abo ...