Mazda 6 Service Manual: Back-up light switch removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Back-up light switch removal/installation

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.

3. Install in the reverse order of removal.

Headlight leveling switch removal/installation

1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Headlight Leveling Switch Removal Note 1. Insert your hand ...

Back-up light switch inspection

1. Disconnect the back-up light switch connector. 2. Inspect for continuity between the back-up light switch terminals using an ohmmeter. If not as specified, replace the back-up light switch ...

Other materials:

Mazda 6 Service Manual: System wiring diagram
ABS (ABS/TCS) DSC FOREWORD Before performing the steps in Symptom Troubleshooting, perform the On-board Diagnostic Inspection. To check the DTC, follow the DTC Inspection steps. ...

Mazda 6 Service Manual: Floor covering
FRONT FLOOR COVERING REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION.) 3. Remove the rear seat. 4. Remove the front scuff plates. 5. Remove the rear scuff plates. 6. Remove the console. 7. Remove the front side tri ...