Mazda 6 Service Manual: Front auto leveling sensor removal/installation
1. Disconnect the negative battery cable.
2. Jack up the vehicle and remove the wheel and tire.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET)
Headlight zeroset
Note
When the configuration is not set for the auto leveling control unit,
headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloade ...
Rear auto leveling sensor removal/installation
1. Disconnect the negative battery cable.
2. Jack up the vehicle.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the headlight zeroset. (S ...
Other materials:
Mazda 6 Service Manual: No.3 passenger-side air bag cut-off indicator light does not illuminate
Diagnostic Procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure connec ...
Mazda 6 Service Manual: Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove the A-pillar trim. (See A-PIL ...