Mazda 6 Owners Manual: Lane-Change Signals and Three-Flash Turn Signal
Lane-Change Signals
Move the lever halfway toward the direction of the lane change—until the indicator flashes— and hold it there. It will return to the off position when released.
Three-Flash Turn Signal
After releasing the turn signal lever, the turn signal indicator flashes three times. The operation can be cancelled by moving the lever in the direction opposite to which it was operated.
NOTE
The three-flash turn signal function can be switched to operable/inoperable using the personalization function.
Turn Signals
Move the signal lever down (for a left turn) or up (for a right turn) to the stop position. The signal will self-cancel after the turn is completed.
If the indicator light continues to flash after a ...
Windshield Wipers and Washer
The ignition must be switched ON to use the wipers.
WARNING
Use only windshield washer fluid or plain water in the reservoir:
Using radiator antifreeze as washer fluid is dangerous. If sprayed on ...
Other materials:
Mazda 6 Owners Manual: Inspection of dtcs for operation mode
Note
The cruise set indicator light will illuminate for 3 seconds? when
operation mode is on.
If the cruise set indicator light does not illuminate for 3
seconds (Operation mode is not on)? the following may be the cause of the
malfunction:
- Cruise actuator ignition power suppl ...
Mazda 6 Owners Manual: Joint shaft removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor and fix it to an appropriate place wh ...