Mazda 6 Owners Manual: Turn and Lane-Change Signals
The ignition must be switched ON to use the turn and lane-change signals.
Fog Lights (Some models)
The fog lights can be turned on with the ignition switched ON and the headlights
turned on.
Use this switch to turn on the fog lights. The fog lights will improve visibility
at night and during f ...
Turn Signals
Move the signal lever down (for a left turn) or up (for a right turn) to the stop position. The signal will self-cancel after the turn is completed.
If the indicator light continues to flash after a ...
Other materials:
Mazda 6 Owners Manual: Inspecting Electrolyte Level
A low level of electrolyte fluid will cause the battery to discharge quickly.
Inspect the electrolyte level at least once a week. If it is low, remove the
caps and add enough distilled water to bring the level between the upper and lower
level (illustration).
Do not overfill.
Examine the sp ...
Mazda 6 Owners Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...