Mazda 6 manuals

Mazda 6 Service Manual: Magnetic clutch adjustment

1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge.


2. Verify that the clearance is within the specification.

Clearance
0.3-0.5 mm {0.012-0.019 in}


Magnetic clutch disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. 3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT.) Bolt Removal/Inst ...

Magnetic clutch inspection
1. Connect battery positive voltage to terminal A of magnetic clutch and ground to A/C compressor body. 2. Verify that the magnetic clutch operates. If not as specified, replace the stator an ...

Other materials:

Mazda 6 Service Manual: Roof molding installation
1. Attach the roof molding to the T stud at the A section. 2. Press in the roof molding along the direction (1) shown in the figure and attach it to the clip A at the B section. 3. Hook the roof molding to the clip B at the C section, press it in, and attach the roof molding to the clip B. ...

Mazda 6 Service Manual: Headliner removal/installation
1. Disconnect the negative battery cable. 2. Turn the seaming welt and weatherstrip over. 3. Remove the sunroof seaming welt. (vehicles with sunroof only) 4. Remove the A-pillar trims. 5. Remove the B-pillar upper trims. 6. Remove the C-pillar trims. 7. Remove the front and rear map light. (Se ...

© 2016-2026 Copyright www.mazda6info.net