Mazda 6 Service Manual: No.18 cooling system concerns-runs cold

No.17 cooling system concerns-overheating

No.19 exhaust smoke

Other materials:

Mazda 6 Service Manual: Thermostat
THERMOSTAT REMOVAL/INSTALLATION 1. Remove the plug hole plate. 2. Disconnect the negative battery cable. 3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) 4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.) 5. Remove the washer tank. 6. Remove the P/S oil pump. Note ...

Mazda 6 Service Manual: Airflow mode actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the airflow mode actuator. 2. Verify that the airflow mode actuator operates as shown below. If not as specified, replace the airflow mode actuator. 3. Verify that the resistance between the ter ...