Mazda 6 Service Manual: On-board diagnostic [multiplex communication system]

Inspection of sst (deployment tool)

Use the SST (Deployment tool) to deploy a live (undeployed) air bag module or pre-tensioner seat belt before disposing of it. Before using the SST (Deployment tool), inspect its operation. ...

Multiplex communication system

Outline In case the controller area network (CAN) system is malfunctioning, read the DTCs of the following modules, using the SST (WDS or equivalent) to determine the malfunctioning system. ...

Other materials:

Mazda 6 Service Manual: Rear drain hose installation
Caution If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and the headliner, always make sure there is no interference with the rear drain hose. Fix any problem if foun ...

Mazda 6 Service Manual: Sunroof relay inspection
Note Sunroof relay is built in the sunroof motor. 1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.) 2. Connect the sunroof switch connector. 3. Measure the voltage at the sunroof relay terminals as indicated below. 4. Disconnect the sunroof relay connector before inspecting fo ...