Mazda 6 Service Manual: Power mos fet inspection
Verify that the resistance between the terminals of the power MOS FET is as shown in the table.
- If not as specified, replace the power MOS FET.
Resistor inspection
Verify that the resistance between the terminals of the resistor is as shown
in the table.
If not as specified, replace the resistor.
POWER MOS FET REMOVAL/INSTALLATION
(See RESISTOR REM ...
Magnetic clutch disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT.)
Bolt Removal/Inst ...
Other materials:
Mazda 6 Service Manual: Sunroof relay inspection
Note
Sunroof relay is built in the sunroof motor.
1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
2. Connect the sunroof switch connector.
3. Measure the voltage at the sunroof relay terminals as indicated below.
4. Disconnect the sunroof relay connector before inspecting fo ...
Mazda 6 Service Manual: No.4 air intake mode does not change
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor contact points are the cause of any intermittent malfunctions.
If there is a problem, check to make sure connectors, terminal ...