Mazda 6 manuals

Mazda 6 Service Manual: Resistor inspection

Verify that the resistance between the terminals of the resistor is as shown in the table.



POWER MOS FET REMOVAL/INSTALLATION

(See RESISTOR REMOVAL/INSTALLATION.)

Resistor removal/installation
1. Disconnect the negative battery cable. 2. Remove the glove compartment. 3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.) 4. Remove in the order indicated in t ...

Power mos fet inspection
Verify that the resistance between the terminals of the power MOS FET is as shown in the table. If not as specified, replace the power MOS FET. ...

Other materials:

Mazda 6 Service Manual: Wheel hub, hub spindle pre-inspection
Wheel Bearing Play Inspection 1. Position a dial indicator against the wheel hub. 2. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play. Maximum wheel bearing play 0.05 mm {0.002 in} 3. If the bearing play exceeds the specification, replace a ...

Mazda 6 Service Manual: Front door unit removal/installation
1. Remove the front door glass. 2. Remove the inner handle. 3. Remove the front door speaker. 4. Disconnect the power window motor connector, front door lock actuator connector, power outside mirror connector. 5. Remove the door harness from the front door unit. 6. Remove the bolts. 7. Rem ...

© 2016-2026 Copyright www.mazda6info.net