Mazda 6 Service Manual: Solar radiation sensor removal/installation
1. Disconnect the negative battery cable.
2. Remove the solar radiation sensor from the dashboard using a tape-wrapped flathead screwdriver.
3. Install in the reverse order of removal.
Magnetic clutch inspection
1. Connect battery positive voltage to terminal A of magnetic clutch and
ground to A/C compressor body.
2. Verify that the magnetic clutch operates.
If not as specified, replace the stator an ...
Solar radiation sensor inspection
1. Shine an incandescent light (60 W) on the solar radiation sensor
from a distance of approximately 100 mm {3.94 in}.
2. Connect positive (+) lead to terminal A and negative (−) lead to term ...
Other materials:
Mazda 6 Service Manual: Blind Spot Monitoring (BSM) Warning Indicator Lights/Display Indicator/ Blind
Spot Monitoring (BSM) Warning Beep
The Blind Spot Monitoring (BSM) or Rear Cross Traffic Alert (RCTA) system notifies
the driver of the presence of vehicles in adjacent lanes or at the rear of the vehicle
using the Blind Spot Monitoring (BSM) warning indicator light, the warning sound
and the display indicator (vehicles with mu ...
Mazda 6 Service Manual: Selector lever disassembly/assembly
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly.
Connector Disassembly Note
1. Insert a thin piece of metal from the terminal side of the connector, and
press down the terminal locking tab.
2. Pull the terminal out of the connector. ...