Note
1. Wear protective eye wear.
2. Lay the stay damper flat.
3. Saw through the stay damper body using a hacksaw.
4. Allow the gas to escape from the stay damper.
5. Discard the stay damper.
Mazda 6 Service Manual: Refrigerant system service procedures
GAS CHARGING SET INSTALLATION
1. Fully close the valves of the SST (49 C061 001).
2. Connect the SSTs (49 C061 002, 49 C061 003) to the high- and
low-pressure side joints of the SST (49 C061 001).
3. Connect the SSTs (49 C061 006A, 49 C061 007) to the ends of the
SSTs (49 C061 002, 49 C061 00 ...
Mazda 6 Service Manual: Inspecting Electrolyte Level
A low level of electrolyte fluid will cause the battery to discharge quickly.
Inspect the electrolyte level at least once a week. If it is low, remove the
caps and add enough distilled water to bring the level between the upper and lower
level (illustration).
Do not overfill.
Examine the sp ...