Mazda 6 Service Manual: Sunroof switch removal/installation
Note
- The sunroof switch is together with the map light.
1. Disconnect the negative battery cable.
2. Remove the map light from the headliner.
3. Install in the reverse order of removal.
Sunroof relay inspection
Note
Sunroof relay is built in the sunroof motor.
1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
2. Connect the sunroof switch connector.
3. Measure the voltage at the sunroof ...
Sunroof switch inspection
1. Remove the sunroof switch.
2. Inspect for continuity between the sunroof switch terminals using an
ohmmeter.
If not as specified, replace the sunroof switch.
...
Other materials:
Mazda 6 Service Manual: Filament repair
1. Use isopropyl alcohol to clean around the damaged section of the filament.
2. Attach tape above and below the damaged section of the filament.
3. Using a small brush or marking pen, repair the filament with silver paint
or equivalent.
4. After 2-3 minutes, carefully remove the tape without ...
Mazda 6 Service Manual: Headlight cleaner nozzle removal/installation
1. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION)
2. Disconnect the headlight cleaner hose. (See HEADLIGHT CLEANER HOSE
REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the headlight cleaner nozzle. ...