Mazda 6 Owners Manual: TCS/DSC Indicator Light
This indicator light stays on for a few seconds when the ignition is switched ON. If the TCS or DSC is operating, the indicator light flashes.
If the light stays on, the TCS, DSC or the brake assist system may have a malfunction and they may not operate correctly. Take your vehicle to an Authorized Mazda Dealer.
Dynamic Stability Control (DSC)
The Dynamic Stability Control (DSC) automatically controls braking and engine
torque in conjunction with systems such as ABS and TCS to help control side slip
when driving on slippery surfaces, or ...
DSC OFF Indicator Light
This indicator light stays on for a few seconds when the ignition is switched
ON. It also illuminates when the DSC OFF switch is pressed and TCS/DSC is switched
off.
Refer to DSC OFF Switch.
I ...
Other materials:
Mazda 6 Owners Manual: Intermittent rear wiper relay inspection
1. Connect the connector to the intermittent rear wiper relay.
2. Connect the negative battery cable.
3. Measure the voltage at the intermittent rear wiper relay using voltmeter.
When inspecting terminal D for continuity, disconnect the intermittent
rear wiper relay connector.
4. If the ...
Mazda 6 Owners Manual: Master cylinder removal/installation
1. Remove in the order indicated in the table.
R.H.D.
L.H.D.
2. Install in the reverse order of removal.
Master Cylinder Installation Note
Caution
Always install the gasket of the power brake unit push rod before
performing measurement inspections or adjustments.
1. Install the ...