Mazda 6 Owners Manual: To Increase Cruising Speed
Follow either of these procedures.
To increase speed using cruise control switch
Press the RESUME/
switch and hold
it. Your vehicle will accelerate. Release the switch at the desired speed.
Press the RESUME/
switch and release
it immediately to adjust the preset speed. Multiple operations will increase the
preset speed according to the number of times it is operated.
Increasing speed with a single RESUME/
switch operation
Instrument cluster display for vehicle speed indicated in km/h: 1 km/h (0.6 mph)
Instrument cluster display for vehicle speed indicated in mph: 1 mph (1.6 km/h)
To increase speed using accelerator pedal
Depress the accelerator pedal to accelerate to the desired speed. Press the SET/
switch and release it immediately.
NOTE
Accelerate if you want to speed up temporarily when the cruise control is on.
Greater speed will not interfere with or change the set speed. Take your foot off the accelerator to return to the set speed.
Cruise Control Switch
Cruise Main Indication (White)/ Cruise Set Indication (Green)
The indication has two colors.
Cruise Main Indication (White)
The indication turns on (white) when ...
To Decrease Cruising Speed
Press the SET/ switch and hold
it. The vehicle will gradually slow.
Release the switch at the desired speed.
Press the SET/ switch and release
it immediately to adjust the preset speed.
Multipl ...
Other materials:
Mazda 6 Owners Manual: Rear outer handle removal/installation
1. Remove the rear door glass.
2. Remove the rear door unit.
3. Remove the rear door latch.
4. Remove the bolts.
5. Detach the rear outer handle and rear door latch rod.
6. With the rear side of the rear outer handle fixed and the outer handle
lever pulled out (1), remove the rear side of t ...
Mazda 6 Owners Manual: Manifold absolute pressure (map) sensor inspection
Note
Perform the following inspection only when directed.
The following vacuum values are indicated by relative pressure
from the MAP sensor.
1. Connect the SSTs (WDS or equivalent) to the DLC-2.
2. Turn the ignition switch to ON (Engine OFF).
3. Select MAP PID on the SSTs (WDS or equi ...