Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning
- When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing the ATF.
1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.)
2. Disconnect the TFT sensor connector.
3. Remove the TFT sensor.
4. Install a TFT sensor.
5. Connect the TFT sensor connector.
6. Install the oil pan. (See CONTROL VALVE BODY INSTALLATION.)
7. Carry out the mechanical system test. (See MECHANICAL SYSTEM TEST.)
Transaxle fluid temperature (tft) sensor inspection
On-Vehicle Inspection
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
Caution
Water or foreign objects entering th ...
Oil pressure switch inspection
Caution
Water or foreign objects entering the connector can cause poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
On-veh ...
Other materials:
Mazda 6 Service Manual: Headlight zeroset
Note
When the configuration is not set for the auto leveling control unit,
headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Connect the SST (WDS or equivalent) to the DLC-2.
4. Turn t ...
Mazda 6 Service Manual: Center panel module removal/installation
1. Cancel the anti-theft operation. (with anti-theft system) (See ANTI-THEFT
SYSTEM.)
2. Disconnect the negative battery cable.
3. Remove the glove compartment.
4. Remove the rear console.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
Caution
...