WARNINGDo not stop the engine while the vehicle is moving: Stopping the engine while the vehicle is moving for any reason other than in an emergency is dangerous. Stopping the engine while the vehicle is moving will result in reduced braking ability due to the loss of power braking, which could cause an accident and serious injury.
1. Stop the vehicle completely.
2. (Manual transaxle)
Shift into neutral and set the parking brake.
(Automatic transaxle)
Shift the selector lever to the P position and set the parking brake.
3. Press the push button start to turn off the engine. The ignition position is off.
CAUTION
When leaving the vehicle, make sure the push button start is off.
NOTE
Replace with a new battery before the key becomes unusable.
Refer to Key Battery Replacement (Vehicle equipped with Type A instrument cluster)
A message is indicated in the display of the instrument cluster.
(Vehicle equipped with Type B instrument cluster)
The KEY indicator light (green) flashes for approximately 30 seconds.
Refer to Warning/Indicator Lights.
If the engine is turned off while the selector lever is in a position other than P, the ignition switches to ACC.
Engine Start Function When Key Battery is Dead
Emergency Engine StopMazda 6 Owners Manual: Power window motor inspection
Drivers Side
1. Disconnect the power window motor connector.
2. Apply battery positive voltage to the power window motor terminals E and F
and inspect the operation the power window motor operation.
If not as specified, replace the power window motor.
3. Apply battery positive voltage ...
Mazda 6 Owners Manual: Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the
connectors.
2. Measure the voltage at the theft-deterrent control module terminals as
indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting
for continuity at terminals L, Q, S, T, a ...