Mazda 6 Service Manual: Tweeter removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Rear door speaker inspection
1. Inspect for resistance between the rear door speaker terminals using an
ohmmeter.
If not as specified, replace the rear door speaker.
2. To verify that the rear door speaker outputs so ...
Tweeter inspection
1. Inspect for resistance between the tweeter terminals using an ohmmeter.
If not as specified, replace the tweeter.
2. To verify that the tweeter outputs sound, apply voltage to the tweete ...
Other materials:
Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire
A jumper wire is used to create a temporary circuit. Connect the jumper
wire between the terminals of a circuit to bypass a switch.
Caution
Do not connect a jumper wire from the power source line to a body
ground. This may cause burning or other damage to wiring harnesse ...
Mazda 6 Service Manual: Variable intake-air system (vis) control solenoid valve inspection (l3)
1. Remove the VIS control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VIS control solenoid valve.
If as specified, carry out the Circuit Open/Short Inspection.
Circ ...