Mazda 6 Service Manual: Cleaning of parts

Mazda 6 Service Manual / General information / Fundamental procedures / Cleaning of parts

All parts to be reused should be carefully and thoroughly cleaned in the appropriate method.

Warning

Using compressed air can cause dirt and other particles to fly out causing injury to the eyes. Wear protective eye wear whenever using compressed air.

Arrangement of parts

All disassembled parts should be carefully arranged for reassembly. Be sure to separate or otherwise identify the parts to be replaced from those that will be reused. ...

Reassembly

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts. If removed, these parts should be replaced with new ones: - ...

Other materials:

Mazda 6 Service Manual: Wheel hub bolt replacement
1. Remove the hub bolt using the SSTs. Note If the dust cover interferes with the wheel hub bolt and the wheel hub bolt cannot be removed, tap the part shown in the figure with a chisel lightly and bend the processing point back to the steering knuckle side. 2. Install the hub bolt i ...

Mazda 6 Service Manual: Inspecting Electrolyte Level
A low level of electrolyte fluid will cause the battery to discharge quickly. Inspect the electrolyte level at least once a week. If it is low, remove the caps and add enough distilled water to bring the level between the upper and lower level (illustration). Do not overfill. Examine the sp ...