Mazda 6 Service Manual: Fundamental procedures
Mazda 6 Service Manual / General information / Fundamental procedures
- Protection of vehicle
- Preparation of tools and measuring equipment
- Special service tools
- Oil leakage inspection
- Disconnection of the negative battery cable
- Removal of parts
- Disassembly
- Inspection during removal, disassembly
- Arrangement of parts
- Cleaning of parts
- Reassembly
- Adjustment
- Rubber parts and tubing
- Hose clamps
- Torque formulas
- Vise
- Dynamometer
- Sst
Units
Conversion to SI Units (Système International d'Unités)
All numerical values in this manual are based on SI units. Numbers shown
in conventional units are converted from these values.
Ro ...
Protection of vehicle
Always be sure to cover fenders, seats and floor areas before starting
work.
...
Other materials:
Mazda 6 Service Manual: Condenser removal/installation
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.)
Caution
If moisture or foreign material enters the refrigeration cycle,
cooling ability will be lower ...
Mazda 6 Service Manual: Clutch disc inspection
1. Using vernier calipers, measure the thickness of the lining at a rivet
head on both sides.
Replace the clutch disc if its thickness is less than the minimum.
Thickness
0.3 mm {0.012 in} min.
2. Measure the clutch disc runout using a dial indicator.
If the runout is excessiv ...
© 2016-2024 Copyright www.mazda6info.net