Mazda 6 Service Manual: Crash zone sensor removal/installation
Warning
- Handling the crash zone sensor improperly can accidentally deploy the air bag module and pre-tensioner seat belt, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the crash zone sensor. (See SERVICE WARNINGS.)
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove the radiator grille.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds
and then goes off.
- If the air bag system warning light does not operate in the manner described above, there are malfunctions in the system. Inspect the system using the on-board diagnostic function.
Curtain air bag module removal/installation
Warning
Handling the air bag module improperly can accidentally deploy the air bag
module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS
before handling the air bag modu ...
Side air bag sensor removal/installation
Warning
Handling the side air bag sensor improperly can accidentally
deploy the side air bag module, which may seriously injure you. Read AIR BAG
SYSTEM SERVICE WARNINGS before handling the ...
Other materials:
Mazda 6 Service Manual: Special tools
ENGINE
Ford SST numbers are collated with Mazda SST numbers in the example below.
Ford SSTs are marked with Ford SST number.
Example
1: Mazda SST number
2: Ford SST number
LUBRICATION SYSTEM
COOLING SYSTEM
FUEL AND EMISSION CONTROL SYSTEMS
CLUTCH
MANUAL TRANSAXLE
AUTOMATIC T ...
Mazda 6 Service Manual: Fan motor
COOLING FAN REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.)
3. Remove the A/C pipe stay.
4. Remove the ATX pipe stay (ATX).
5. Remove in the order indicated in the table.
6. Install in the reverse order of remo ...