1. Connect the SSTs to the brake pipes as shown in the figure.
2. Bleed the air from the brake system.
3. Measure the fluid pressure of the master cylinder and the rear brake.
Fluid pressure
Mazda 6 Service Manual: Running light unit inspection
1. Connect the connector to the running light unit.
2. Connect the negative battery cable.
3. Measure the voltage at the running light unit using voltmeter.
When inspecting terminal D, H or P for continuity, disconnect the running light unit connector.
4. If the value are not as specif ...
Mazda 6 Service Manual: Driving Position Memory (Some models)
The desired driving position can be called up after programming the position.
The following driving positions can be programmed.
Driver’s seat position (seat slide, height adjustment, front edge of seat
bottom, seat recline)
Active driving display (display position, brightness level, dis ...