Mazda 6 Service Manual: Headlight cleaner motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Remove the washer fluid-level sensor. (See WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
Wiper and washer switch inspection
Windshield Wiper And Washer Switch
Without vehicle-speed sensing type wipers
1. Remove the wiper and washer switch. (See WIPER AND WASHER SWITCH
REMOVAL/INSTALLATION)
2. Inspect for continuity be ...
Headlight cleaner motor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Connect battery positive voltage to terminal D and ground to terminal C of
the motor. ...
Other materials:
Mazda 6 Service Manual: Neutral switch inspection
Note
Perform the following inspection only when directed.
Continuity Inspection
1. Disconnect the negative battery cable.
2. Remove the neutral switch.J5 MANUAL TRANSAXLE REMOVAL/INSTALLATION.)
3. Inspect for continuity between the neutral switch terminals using an
ohmmeter.
If the n ...
Mazda 6 Service Manual: Heated Steering Wheel (Some models)
The grips on the left and right of the steering wheel can be warmed up.
The ignition must be switched ON.
Press the switch to turn on the heated steering wheel. The heated steering wheel
operates for about 30 minutes and then turns off automatically.
The indicator light illuminates when the h ...