Mazda 6 Service Manual: Headlight cleaner motor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Connect battery positive voltage to terminal D and ground to terminal C of the motor.
4. Verify that the headlight cleaner motor operates.
- If the motor does not operate, replace the headlight cleaner motor.
Headlight cleaner motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Remove the washer fluid-level sensor. (See WASHER FLUID-LEVEL SENSOR
REMOVAL/INSTALLA ...
Headlight cleaner nozzle removal/installation
1. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION)
2. Disconnect the headlight cleaner hose. (See HEADLIGHT CLEANER HOSE
REMOVAL/INSTALLATION)
3. Remove in the order indicated in ...
Other materials:
Mazda 6 Service Manual: Parking brake (lever type) adjustment
1. Start the engine and depress the brake pedal several times.
2. Stop the engine.
3. Remove the ashtray behind the center console.
4. Turn the adjusting nut as shown in the figure.
5. After adjustment, inspect the following points:
(1) Turn the ignition switch to ON, pull the parking brak ...
Mazda 6 Service Manual: To Temporarily Cancel
To temporarily cancel the system, use one of these methods:
Slightly depress the brake pedal.
(Manual transaxle) Depress the clutch pedal.
Press the OFF/CANCEL switch.
If the RESUME/ switch is
pressed when the vehicle speed is 25 km/h (16 mph) or higher, the system reverts
to the prev ...