Mazda 6 Service Manual: Ignition coil inspection
Primary Coil Winding
1. Remove the ignition coil.
2. Measure the resistance between the following lead holes using an ohmmeter.
- A and B, B and C
- If not specified, replace the ignition coil.
Specification
0.49-0.57 ohms [20°C {68°F}]
Secondary Coil Winding
1. Remove the ignition coil.
- 1 and 4
- 2 and 3
- If not specified, replace the ignition coil.
Specification
9.5-11.1kilohms
Insulation Resistance of Case
1. Disconnect the high-tension lead.
2. Disconnect the ignition coil connector.
3. Measure the insulation resistance between the following terminals and ignition coil case using an ohmmeter.
- Terminal B and ignition coil case.
- If not specified, replace the ignition coil.
Specification
Above 10 Megohm
Ignition coil removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
...
Spark plug removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. ...
Other materials:
Mazda 6 Service Manual: Auto Lock/Unlock Function
WARNING
Do not pull the inner handle on a front door: Pulling the inner handle
on a front door while the vehicle is moving is dangerous. Passengers can fall out
of the vehicle if the door opens accidentally , which could result in death or serious
injury.
When the vehicle speed exceeds 20 ...
Mazda 6 Service Manual: Front door removal/installation
1. Disconnect the negative battery cable.
2. To remove the front door hinge, remove the front fender panel.
3. To remove the checker, remove the door speaker.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the front door. (See DOOR ADJUS ...