Caution
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
4. Disconnect the input/turbine speed sensor connector.
5. Measure resistance between the terminals of the input/turbine speed sensor.
Resistance
250-600 ohms (ATF temperature: -40-160 °C {-40-320 ° F})
6. Connect the input/turbine speed sensor connector.
7. Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
8. Install the battery and battery tray.
9. Connect the negative battery cable.
Mazda 6 Service Manual: Transaxle oil replacement
1. Remove the drain plug with the washer.
2. Drain the oil into a suitable container.
3. Install a new washer and the drain plug.
Tightening torque
40-58 N·m {4.0-6.0 kgf·m, 29-43 ft·lbf}
4. Remove the oil level plug with washer and add nthe specified amount and
type of oil through t ...
Mazda 6 Service Manual: General procedures
Wheels and Tires Removal/Installation
The removal and installation procedures for the wheels and tires are not
mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m
{9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
Power Steering Components Removal/Installation
If any power steeri ...