Mazda 6 Service Manual: Inspection of sst (deployment tool)
- Use the SST
(Deployment tool) to deploy a live (undeployed) air bag module or pre-tensioner seat belt before disposing of it.
- Before using the SST
(Deployment tool), inspect its operation.
Inspection Procedure
Follow the steps below to verify that the SST
(Deployment tool) is operating correctly.
- If not as specified, do not use the SST
(Deployment tool) because it may cause the air bag module or pre-tensioner seat belt to unexpectedly deploy upon connection to the air bag module or pre-tensioner seat belt.
Air bag module and pre-tensioner seat belt disposal procedures
Warning
Before scrapping a vehicle with a live (undeployed) air bag module
and pre-tensioner seat belt, deploy the air bag module and pre-tensioner
seat belt. Never dispose of a live (undepl ...
Other materials:
Mazda 6 Service Manual: Cargo compartment light switch inspection
1. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
2. Disconnect the cargo compartment light switch connector.
3. Inspect for continuity between the cargo compartment light switch
terminals using an ohmmeter.
If not as specified, replace the liftgate lock.
...
Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there is a
problem, check to make sure conne ...