Mazda 6 Owners Manual: Manual Switching
Switching to low beams
Shift the lever to the low beam position. The High Beam Control System (HBC) indicator light (green) turns off.
Switching to high beams
Turn the headlight switch to the
position.
The High Beam Control System (HBC) indicator light (green) turns off and the
is illuminated.
To Operate the System
The High Beam Control System (HBC) operates to switch the headlights automatically
between high and low beams after the ignition is switched ON and the headlight switch
is in the AUTO and high bea ...
Blind Spot Monitoring (BSM) (Some models)
The Blind Spot Monitoring (BSM) is designed to assist the driver in checking
the area to the rear of the vehicle on both sides during lane changes by notifying
the driver of the presence of vehicl ...
Other materials:
Mazda 6 Owners Manual: Side protector installation
1. Remove the adhesive remaining on the side protector (if it will be reused)
and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector
(if it will be reused) and the body.
3. Attach double-sided adhesive tape to the side protector as shown (if it ...
Mazda 6 Owners Manual: Oil cooler removal/installation
1. Disconnect the negative battery cable.
2. Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT.)
3. Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add ATF to ...